&
|
|---|
| Bojin > Leisure-Line > Knots and fishing tips |
|---|
 |
| Stren "J" Knot Perfect For Joining Braid to Mono Line |
|
1.Lay the line and leader alongide each other, overlapping about 12 inches. |
 |
| 2.Treating the two like a single line, tie an overhand knot, pulling the entrire leader through the loop. |
 |
| 3.Lerve the loop of the overhand knot open, pull the ends of both line and leader through the bottom of the over-hanging loop,and then through the top again.(For a mono leader to braid connection, pull the tag ends through the bottom once agin. |
 |
| 4.Holding both lines and both ends, begin to draw the knot slowly and evenly. If the knot appears to have loose sec-tions affer the initial draw down, be sure to pull the loose ends tightly into the knot. Make sure the knot is tight and commpact by pulling all ends snugly. |
 |
| 5.Trim ends closely. |
 |
| Double Uni Knot For Joining Two Line |
|
1.Overlap approximately 12 inches of the ends of two lines. Form a Uni-kont circle with the tag end of Line "A" |
 |
| 2.Wrap "Line A" 2-6 times to from a Uni-Knot around " Line B ".Note: for 4-20 lb. test monofilament lines, use 6 turns; for 25-40lb. test mono, use 4-5 turns; for 50-80 lb. mono, use 3-4 turns;and for 100lb. test or greater mono, use 2-3 turns. |
 |
| 3.Snug the knot by pulling on both ends of "Line A". |
 |
| 4.Form an 8-11 turn lmproved Clinch Knot in "Line B"(for braids/superline, go with 10-12 turns) by wrapping "Line B "8-11 time around "Line A", the threading the tag end of "Line B" through the opening at the base of the Uni Knot, and the through the big loop. |
 |
| 5.Hold the tag end and standing line while pulling up the coils of " Line B". Make sure the coils are in a spiral as opposed to overlapping each other. Slide tight against the Uni Knot, jamming them togethe, then trim. |
 |
| 6.The finished Double Uni Knot. |
 |
|